Exterior View
Product Specs
Generator Set Specifications
- Maximum Rating
- 800 ekW
- Minimum Rating
- 635 ekW
- Emissions/Fuel Strategy
- Low Fuel Consumption
- Voltage
- 220 to 480 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- 3412C TA, V-12, 4-Stroke Water-Cooled Diesel
- Bore
- 5.4 in
- Stroke
- 6 in
- Displacement
- 1648.86 in³
- Compression Ratio
- 13:00:01
- Aspiration
- TA
- Fuel System
- Pump and Lines
- Governor Type
- ADEM™ A5
Generator Set Dimensions
- Length - Maximum
- 162.4 in
- Width - Maximum
- 78.3 in
- Height - Maximum
- 75 in
- Dry Weight - Genset (minimum)
- 5761 lb
- Dry Weight - Genset (maximum)
- 13275 lb
Standard Equipment
-
- Air Inlet System
-
- Air cleaner, single element canister type
- Single element canister type
-
- Control Panel
-
- High coolant temperature
- Customer data link (Modbus RTU)
- Low coolant temperature
- Low coolant level
- Communications:
- Run/auto/ stop/control
- Engine cycle crank
- Generator temperature monitoring module
- Power factor (per phase & average)
- Remote CAN annunciator
- Serial annunciator module data link
- DC volts
- Frequency (Hz)
- Operating hours.
- Emergency stop pushbutton
- Digital I/O module
- Local annunciator
- Low oil pressure
- Oil pressure (psi, kPa or bar)
- Emergency stop
- Warning shutdowns:
- Volts (L-L & L-N)
- Remote Serial annunciator
- Speed adjust
- Amps (per phase & average)
- Voltage adjust
- EMCP 4.2B
- Overspeed
- coolant temperature
- Digital Indicator for:
- RPM
- Accessory module data link
- Failure to start (overcrank)
- Controls:
- Compatible with the following optional modules:
-
- Cooling System
-
- Caterpillar extended life coolant
- Radiator with guard (sized for 50 degrees C)
- Fan and belt guards
- Coolant drain line with valve
-
- Exhaust System
-
- Stainless steel exhaust flex with ANSI style outlet flange
-
- Fuel System
-
- Primary and Secondary fuel filters
- Fuel priming pump
- Water separator
-
- Generator And Attachments
-
- 3 Phase sensing
- SR4B self excited
- Class F temperature rise
- VR6B voltage regulator
- Busbar termination
- 12 Leads
- Class H insulation
- 2:1 Volts/Hz
- Reactive droop
-
- Governing System
-
- Cat electronic governor
-
- Lube System
-
- Oil drain line with valve
- Lubricating oil
- Oil filter
-
- Mounting System
-
- Base, formed steel with linear vibration isolators between base and engine-generator
-
- Starting / Charging System
-
- Battery with rack, cables
- 45 Amp Charging alternator
- Fuel shutoff solenoid
- 24 Volt starting motor
-
- General
-
- Paint - Caterpillar yellow except rails and radiators gloss black
Attachments
-
- Air Inlet System
-
- Air cleaner - Dual element
- Air cleaner - Heavy element
- Air cleaner - single element
-
- Certificates
-
- EU Certification
-
- Circuit Breakers
-
- 4 Pole Circuit breakerswith shunt trip
- 3 Pole Circuit breakers with shunt trip
- Power terminal strip
-
- Control Panel
-
- EMCP 4.3, EMCP 4.4
- Temperature monitoring package
- Vandal proof panel door
- Generator running VFC
- Earth leakage Ground fault relay
- Common alarm/shutdown relay
-
- Cooling System
-
- Jacket water heater
- Radiator duct flange
- Radiator removal
-
- Exhaust System
-
- Muffler 10 dBA attenuation
- Manifold and turbocharger guards
- Muffler 35 dBA attenuation
- Elbow mounting kit
- Through wall installation kit
-
- Fuel System
-
- Manual fuel transfer pump
- Automatic fuel transfer system
-
- Generator And Attachments
-
- Internal excitation (IE)
- Anti-condensation heater
- Permanent magnet excitation (PMG)
- Oversize and premium generators
-
- Governing System
-
- Electronic load share
-
- Lube System
-
- Manual sump pump
-
- Mounting System
-
- Fuel tank base (1200 Ltr)
-
- Special Tests / Reports
-
- PGS Test report @ 1.0 power factor
- PGS Test report @ 0.8 power factor
- Factory witness test
-
- Starting / Charging System
-
- Oversize battery set
- Battery chargers
- Heavy duty starting system
- Battery disconnect switch
- Battery removal
-
- Enclosures
-
- DC lighting package
- Weather protective enclosure (WP)
- Sound attenuated enclosure (SA)