Product Specs
Ratings
- Power Range
- 803 - 1136 bhp, 599 - 847 bkW
Engine
- Speed Range
- 2100-2300 rpm
- Emissions
- EPA Tier 3, IMO II
- Aspiration
- TA,TTA
- Bore
- 5.7 in
- Stroke
- 7.2 in
- Displacement
- 1106 in³
- Rotation from Flywheel End
- Counterclockwise
- Configuration
- In-line 6, 4-Stroke-Cycle Diesel
Dimensions & Weights
- Maximum Length
- 76 in
- Minimum Length
- 73 in
- Maximum Dry Weight
- 4299 lb
- Minimum Height
- 47.2 in
- Maximum Width
- 47.4 in
- Minimum Dry Weight
- 4000 lb
- Maximum Height
- 51.2 in
- Minimum Width
- 44.6 in
Standard Equipment
- 
            
            - Air Inlet System
- 
                        - Separate circuit after-cooled (SCAC)
- Open Crankcase Ventilation (OCV) system
- Turbocharger, jacket water cooled
- Front-down and rear-down aftercooler condensate drains
 
 
- 
            
            - Cooling System
- 
                        - Separate Circuit After-Cooling (SCAC) for both HEX and Keel cooled engines
- Engine JW and SCAC Shell & Tube Heat Exchangers for HEX cooled engines
- SCAC pump, gear driven, for HEX cooled engines only
- Jacket water pump, gear driven
- Sea water pump, bronze impeller, gear driven
- SCAC and JW shunt tanks for maintaining proper pump inlet pressures
 
 
- 
            
            - Exhaust System
- 
                        - Water-cooled exhaust manifold & turbocharger
- 152 mm (6 in) round flanged outlet
 
 
- 
            
            - Flywheels & Flywheel Housings
- 
                        - Flywheel Housing, SAE No. 0
- Flywheel, 18 inch, 136 teeth
- SAE standard rotation
- SAE No. 1, Flywheel: 14 inch, 113 teeth
 
 
- 
            
            - Fuel System
- 
                        - Front service simplex fuel system
- Fuel transfer pump, gear driven
- Manual fuel priming pump
- Hybrid fuel line design
 
 
- 
            
            - Lube System
- 
                        - Front service simplex oil system
- Center sump oil pan:
- Front and top service oil filler locations
- Front service dipstick
- Oil pump, gear driven
 
 
- 
            
            - Power Take-offs
- 
                        - Poly-V groove for alternator drive
- NOTE: There are no standard power take-offs available
 
 
- 
            
            - General
- 
                        - Front damper guard
- Front service engine
- Common electrical bonding point
- Engine does not ship with zinc components
- Engine is certified to D2/E2 emissions cycles
- CERTIFIED TO 2013 EPA TIER 3 AND IMO II MARINE COMMERCIAL PROPULSION (E3 CYCLE) EMISSION STANDARDS
- CERTIFIED TO EU STAGE IIIA AND CCNR STAGE II (E3 CYCLE) EMISSIONS STANDARDS.
- NOTE: Ratings listed below can also be used in Recreational / Pleasure Craft applications.
 
 
- 
            
            - Control System
- 
                        - Programmable low idle
- WOSR (Wide Operating Speed Range) available for EPA Tier 3 - B and C Ratings
- Adjustable High Idle (TEL) - EPA Tier 3 WOSR Ratings Only
- Electronic diagnostics and fault logging
- Engine and transmission monitoring (speed, temperature, pressure)
- Electronic fuel/air ratio contro
- Engine Protection Mode for extended ambient conditions - EPA Tier 3 Ratings Only
- Torque Limiting functionality for WOSR ratings only
- 70-pin customer connector
- Three types of throttle inputs (primary/ secondary PWM, 0-5V, 4-20mA +/-
 
 
Attachments
- 
            
            - Exhaust System
- 
                        - Dry Elbows
- Water-Cooled Elbows
- Flexible Fitting
- Flange
- Muffler
- Muffler Spark Arresting
 
 
- 
            
            - Charging System
- 
                        - Battery Chargers
- Charging Alternators
- Alternator Mounting Group
- Ammeter
 
 
- 
            
            - Control System
- 
                        - MECP I
- CATERPILLAR ALARM AND PROTECTION
 
 
- 
            
            - Cooling System
- 
                        - AUX EXPANSION TANK FLANGE KIT
 
 
- 
            
            - Fuel System
- 
                        - Duplex Fuel Filters
- Flexible Fuel Lines
- Fuel Cooler
- Primary Fuel Filters
 
 
- 
            
            - Instrumentation
- 
                        - Instrument Panels
- OEM Wiring Harness
- Engine to Engine Harness
- Gauges
- Transmission Sensors
- Oil Level Sensor
 
 
- 
            
            - Lube System
- 
                        - Duplex Oil Filters
- Transmission Oil Cooler
- Sump Pump
 
 
- 
            
            - Mounting System
- 
                        - Vibration Isolators
- Front Support
- Rear Support
 
 
- 
            
            - Power Take-offs
- 
                        - NOTE: PTO OPTIONS REQUIRE TORSIONAL VIBRATION ANALYSIS
- Crankshaft Pulleys
- Front Stub Shaft
- Hydraulic Pump Drive Adapter
- Front Enclosed Clutch
 
 
- 
            
            - Protection System
- 
                        - Marine Classification Society and SOLAS
- Marine Classification Society and Fire Resistance
 
 
- 
            
            - Starting System
- 
                        - STARTING SYSTEM Electric Starting Motors - Single 24 Volt
- Air Starting Motor
- Air Start Accessories
- Starting Aids - JW Heaters
- Battery Sets - 24 Volt - Dry
 
 

 Exterior View
 
                        		                        		Exterior View	                        		
                        	