Product Specs
Power Rating
- Maximum Power
- 74 HP
- Maximum Torque
- 199 lb-ft @ 1600 rpm
- Rated Speed
- 2800 rpm
- Minimum Power
- 49 HP
Emission Standards
- Emissions
- EU Stage V, U.S. EPA Tier 4 Final, Japan 2014 (Tier 4 Final)
General
- Engine Configuration
- In-Line 4, 4-Stroke-Cycle Diesel
- Bore
- 3.3 in
- Stroke
- 3.9 in
- Displacement
- 135 in³
- Compression Ratio
- 17.0:1
- Aspiration
- Turbocharged or Turbocharged Aftercooled
- Combustion System
- Direct Injection
- Rotation from Flywheel End
- Counterclockwise
Power Unit Dimensions
- Weight
- 721 lb
Standard Equipment
-
- Control System
-
- Alternator 12 volt 85 amp
- Starter motor 12 volt
- Glow plug starting aid, delivers heat directly to cylinder for best starting performance in cold weather
- Electronic control unit - chassis mounted
- Flexible and configurable software features and well supported SAE J1939 CAN bus enables highly integrated machines
- Wiring harness connectors and sensors are waterproof and designed to withstand harsh off-highway environments
-
- Flywheels And Flywheel Housing
-
- SAE No. 4 standard flywheel housing
- Choice of flywheel weight and bolting pattern to accommodate a range of industry-standard hydraulic pumps and transmissions
-
- Fuel System
-
- 2000 bar high-pressure common rail system
- Proprietary fuel filters to ensure engine protection through correct service procedures, along with water-in-fuel detection, ensures maximum machine up-time for the operator
-
- Lube System
-
- Alternative oil fillers
- Spin-on lube oil filter
-
- Power Take Off (pto)
-
- SAE A PTO drive
-
- General
-
- Cast iron engine block
- Cast iron exhaust manifold
- Gradeability 35° continuous
- Paint: Cat yellow
-
- Aftertreatment/clean Emissions Control Equipment
-
- Diesel Oxidation Catalyst (DOC)
- Diesel Particulate Filter (DPF)