Product Specs
Ratings
- Power Range
- 578-609 mhp (570-600 bhp)
Engine
- Speed Range
- 2300 rpm
- Emissions
- IMO I
- Aspiration
- TA
- Bore
- 5.1 in
- Stroke
- 5.9 in
- Displacement
- 732 in³
- Rotation from Flywheel End
- Counterclockwise
- Configuration
- In-line 6, 4-Stroke-Cycle Diesel
Dimensions & Weights
- Height
- 39.5 in
- Length
- 62 in
- Width
- 38.1 in
- Dry Weight
- 2588 lb
Standard Equipment
- 
            
            - Air Inlet System
- 
                        - Aftercooler - sea water; corrosion resistant, Air Cleaner/Fumes Disposal (closed system), Turbocharger, Jacket Water Cooled
 
 
- 
            
            - Control System
- 
                        - Electronic governing, Cold mode start strategy, Power compensation for fuel temperature, Programmable low idle, Electronic diagnostics and fault logging, Engine and transmission monitoring (speed, temperature, pressure), Fuel/air ratio control, Emergency stop switch (A&B ratings only)
 
 
- 
            
            - Cooling System
- 
                        - Thermostat and housing, Jacket water pump; gear driven, Sea water pump; rubber impeller; self-priming; gear-driven, Integral heat exhanger/expansion tank; removable tube bundle; replaceable copper-nickel tubes, Keel cooling - combined circuit (includes pipe thread flange kit)
 
 
- 
            
            - Exhaust System
- 
                        - Watercooled Manifold & Turbocharger
 
 
- 
            
            - Flywheels & Flywheel Housings
- 
                        - Flywheel; SAE No. 1; 113 teeth, Flywheel housing; SAE No. 1 (10 degree slant pad), SAE standard rotation
 
 
- 
            
            - Fuel System
- 
                        - Fuel filer; RH service on Port; LH service on Starboard, Fuel transfer pump, Fuel priming pump, Flexible fuel lines
 
 
- 
            
            - Instrumentation
- 
                        - Service meter, electric
 
 
- 
            
            - Lube System
- 
                        - Crankcase breather, Oil cooler, Oil filter; spin-on; RH service on Port; LH service on Starboard, Oil filler, Dipstick; RH service on Port; LH service on Starboard, Oil pump; gear driven
 
 
- 
            
            - Mounting System
- 
                        - Front support
 
 
- 
            
            - Power Take-offs
- 
                        - Hydraulic pump drive; SAE A; 11 tooth spline, 57 ft-lbs max torque; counterclockwise as viewed from the rear of hte engine looking into the pump drive and turns 1.41 x engine speed, Crankshaft pulley; 345 mm (13.6 in) single groove; 15.88 mm (.63in) width
 
 
- 
            
            - Protection System
- 
                        - Shutdown; electronic; 12 or 24 volt; energized to run
 
 
- 
            
            - General
- 
                        - Vibration damper, Lifting eyes, RH or LH service options, Literature, Variable engine wiring, Upper rear-facing customer wiring connector and ECAP connection, Electronic installation kit (connectors, pins, sockets)
 
 
Attachments
- 
            
            - Air Inlet System
- 
                        - Low Profile Air Inlet Line, Shield (Air Inlet Line)
 
 
- 
            
            - Charging System
- 
                        - Charging Alternators, Voltmeter Guages, Voltmeter Guage Mounting, Alternator Mounting Group
 
 
- 
            
            - Cooling System
- 
                        - Sea Water Pump, Coolant Recovery Tank, Flange Kit
 
 
- 
            
            - Exhaust System
- 
                        - Flexible Fitting, Elbow, Dry Elbow, Watercooled Elbow, Exhaust Connection, Exhaust Outlet Pipe, EXH Outlet Flange, Rain Cap, Muffler
 
 
- 
            
            - Fuel System
- 
                        - Fuel Cooler, Fuel Connections, Primary Fuel Filter, Primary Fuel/Water Separator
 
 
- 
            
            - Instrumentation
- 
                        - OEM Wiring Harness, Engine to Engine Harness, Digital Tachometer, Tachometer Mounting, Magnetic Pickup, RH 4 Hole Instrument Panel, LH 4 Hole Instrument, Marine Power Display System, Marine Power Display Unit (for additional monitoring stations), Marine Power Display Bracket, Wiring Group, Transmission Sensors
 
 
- 
            
            - Lube System
- 
                        - Manual sump pump, Transmission oil cooler
 
 
- 
            
            - Mounting System
- 
                        - Vibration Isolators
 
 
- 
            
            - Power Take-offs
- 
                        - Crankshaft Pulley, Front Stub Shaft, Front Stub Shaft & Pulley
 
 
- 
            
            - Starting System
- 
                        - Air Pressure Regulator, Air Start Silencer, Start Switch, Jacket Water Heater, Battery sets (24 volt - dry)
 
 
- 
            
            - General
- 
                        - Wiring Harness Removal, Belt Guard - Alternator, Belt Guard - Alternator Pulley, Filter Cover Kit
 
 
- 
            
            - Packing
- 
                        - Overseas Preservation, Engine Protective Cover, Storage Preservation, Export Packing
 
 

